2. Product Overview
DP-OPT-TX150, DP-OPT-RX150 – User's Manual
10
Applied firmware package: v1.1.13 | LDC software: v2.5.1b5
2.2.
DP-OPT-RX150
Front View
1
POWER LED
▪
ON:
the unit is powered on.
▪
BLINKING:
an error has occurred and device is out of normal operation, or it is in bootload mode
(during firmware upgrade).
2
FIBER LINK LED
▪
ON:
the link is active between the extenders and ready to use.
▪
BLINKING:
is no connection between the extenders.
3
SOURCE LED
▪
ON:
powered DP source is connected to the transmitter.
▪
BLINKING:
an HDMI adaptor cable is connected to the receiver to indicate HDMI mode operation.
4
HDCP LED
▪
ON:
DP signal transmission is in progress or HDCP encryption is enabled during DVI/HDMI transmission.
▪
OFF:
a DVI or HDMI display is connected to the receiver (via an adaptor cable) and HDCP is disabled
(thus the source is forced to send non-encrypted stream). For more information about HDCP setting,
section.
5
USB LINK LED
▪
ON:
HID extension is active.
▪
BLINKING:
the USB channel is ready to use but HID extension is not active (e.g. there is no USB HID
device connected to the receiver or the computer is powered off).
▪
OFF:
the USB channel between the extenders is not ready.
6
K+M EMULATE LED
▪
OFF:
the transmitter is in transparent USB mode (default).
▪
BLINKING:
the transmitter is in configuration USB mode.
1
2
3
4
5
6
Rear View
1
DC connector
Connect the output of the su5 V power adaptor. Lightware’s rack
mountable power supply can also be used (PSU2x10-200 or PSU2x20-400).
2
USB mini-B connector
USB mini-B type connector for control functions (with Lightware Device
Controller) and firmware upgrade.
3
USB-A ports
Ports for USB HID (Human Interface Device, e.g. mouse, keyboard, or
presenter) and USB HUB devices (e.g. keyboard with built-in USB HUB).
Only HID devices are extended to the source computer. (The symbols are
just recommendations; mouse can be plugged into the port indicated with
keyboard-symbol and vice versa.)
4
DisplayPort output
DisplayPort 1.1a output connector for display devices with DisplayPort
connector. The applied DP-DP cable shall not be more than 2 m. DP
adapters with DVI or HDMI connector are also supported. See the
section for more information about the connector.
5
SC Fiber connector
SC fiber optical input connector. Connect to the transmitter by a single
multimode fiber cable.
1 2
4
5
3
