Lightware 91540021, User Manual

Page: 38 / 119

5.SoftwareControl-LightwareDeviceController HDMI-TPS-RX110AY series – User's Manual 38
Appliedfirmwarepackage:v1.4.0 | LDCsoftware:v2.4.0b3
5.7. Control Menu
5.7.1. RS-232
RS-232 tab in Control menu
Thefollowingsettingsandfunctionsareavailable(bothonlocalandTPSserialports):
▪ Operationmode:Pass-through,Control,orCommandInjection(formoredetailsaboutserialinterface
modes see the Serial Interface section);
▪ Baudrate:4800,7200,9600,14400,19200,38400,57600,115200;
▪ Databits:8or9;
▪ Parity:None,Odd,orEven;
▪ Stopbits:1,1.5,or2;
▪ Commandinjection:enableordisable;
▪ Command injection port number;
▪ Controlprotocol:LW2orLW3;
▪ Message sending via serial port;
▪ Reloading factory defaults (see factory default settings in the Factory Default Settings section).
ATTENTION! Operation mode of the local and TPS serial ports can be set together only. It means if you set the
local RS-232 port to Control mode, the TPS serial link will be changed to Control mode either automatically.
ATTENTION! IfthereceiverisconnectedtoaTPS2outputboardofamatrixframe,theRS-232configuration
settings (baud rate, data bits, e.t.c.) will not be changeable on the receiver side.
#rs232 #rs-232 #serial #commandinjection #message
Message Recognizer
DIFFERENCE: This feature is available only in HDMI-TPS-RX110AY-Plus model.
HDMI-TPS-RX110AY-Plus model can analyze and
store the received serial data. For more information
see the RS-232 Recognizer section.
Put a tick to
Enable message recognizer on this port
to
switch the recognizer on.
Delimiter sequence
text box is for set the delimiter
stringinhexformat.Whenthisstringisdetected
in the incoming serial data, the device saves the
RS-232messagedatafromthefirstbit,untilthe
delimiter (or the data between the two delimiters).
INFO: 0D0A is the factory default value, this is
the hexadecimal code of Carriage Return and
Line Feed. LW3 protocol commands ended
with this formula, so the default value support
therecognitionoftheLW3commandsandthe
stored changes automatically.
If the
Timeout
is enabled and set, the received data
is saved when the timeout is elapsed after the last
received message.
In
Received messages
box shows the last received
and stored message in Text (RECOGNIZER.Rx), Hex
(RECOGNIZER.RxHex), and Hash (RECOGNIZER.
Hash) format. The Hex and Hash contains the
delimiter.
Press the
Clear
button to erase this storage.
Clicking on
Reload
restores the Factory Default Settings of the recognizer.
ATTENTION! TheMessagerecognizersettingsaremirroredontheLocalandTPSinserialports.
INFO: Message recognizer operates independently of the RS-232 mode.
#recognizer #rs232recognizer #rs-232recognizer
  
