LightPointe AireLink 60, Installation And User Manual, Page: 52 / 133

AireLink

60 Installation and User Manual Rev. D Recommended Software Pre-Configurations
Page 52
4 RECOMMENDED SOFTWARE PRE-CONFIGURATIONS
Before installing the radio on the roof, we recommend to perform a few simple software pre-
configurations. These basic settings are important to access the management interface/web browser.
4.1 REQUIRED NETWORK SETTINGS INFO
Please, ask the Network Administrator to provide the following information:
1. IP Address for both 60 GHz radios(Pre-configured IP address is 192.168.1.10)
2. Subnet Mask (Pre-configured subnet mask is 255.255.255.0)
3. Default Gateway Address (Pre-configured gateway address is 192.168.1.1)
4. Password for CLI access (default password is admin )
5. Password for WEB BROWSER access (default password is admin )
Besides these basic settings, additional settings (e.g. SNMP community settings, VLAN settings, etc.)
can be configured via the TELNET CLI interface (see Chapter 7.). Alternatively, configuration changes
can be performed via the web browser interface (see Chapter 6.).
4.2 AIRELINK CONFIGURATION VIA TELNET CLI INTERFACE
Please perform the following steps to connect the ODU to the serial port:
Step 1
Connect the AireLink Management and PoE Port to the Output of the PoE
Injector using a straight-through Cat5E cable. Plug the PoE Injector into a 110
or 240VAC outlet. The AireLink system will now power up and initialize.
Depending on the software load this process can take up to 2 minutes.
The boot process is completed when the Power LED on the back panel
(see Figure 3-2) stops blinking and is solid green.