LightPointe AireLink 60, Installation And User Manual, Page: 48 / 133

AireLink

60 Installation and User Manual Rev. D Networking, Power and Service Connections
Page 48
3.4 NETWORK DATA CONNECTION
The AireLink™ 60 has a Combo networking data port located on the user panel (see Fig. 3-1). The
system is shipped standard with a copper 100/1000 Base-TX RJ-45 connector. Auto-MDIX
configuration automatically detects the required cable connection type and configures the connection
appropriately, removing the potential need for crossover cables. If required by the specific setup, the
port speed and simplex/duplex operation can also be fixed via the web browser/ management software.
Alternatively, the combo port can be equipped with a Gigabit Ethernet SFP fiber transceiver slot.
Please, ask LightPointe sales/customer support for details and recommendations on suitable SFP fiber
transceivers.
Fig. 3-8 below shows how the AireLink™ 60 is connected to the network.
`
MXA
SPEED
DUPLX STAT
SYST
RPS
Catalyst 2960 Series 2 1 4 3 6 5 8 7 10 9 12 11 14 13 16 15 18 17 20 19 22 21 24 23
1 2
2X
1X
12X
11X
14X
13X
24X
23X
Indoor PoE Injector
110-240 Vac
CAT5E/6 Copper
PoE + Out-of-Band
Management Connection
Out-of-Band Management
Connection (optional*)
Data connection
to PC/Laptop
Copper/ Fiber Network Data
Connection
Lightpointe surge protector
LM-=SURGE-1
Figure 3-8: Data Network Connection
The Combo data port acts as a single network connection. This means that
EITHER the RJ-45 copper port OR the SFP port should be connected to the
network at the same time. Connecting both ports in parallel can/will cause
networking problems.