background image

SOCKET

CANOPY ASSEMBLY

BOTTOM PLATE

SPACE NECK

KEYSLOTS

REFLECTOR

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This fixture is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

INSTRUCTION SHEET NO.

IS:40411

1198

Page 1 of 1

STUD

WIRE NUTS

CROSSBAR

1. Thread STUD into CROSSBAR as shown (fig.1).
2. Using appropriate slots in CROSSBAR, secure

CROSSBAR to OUTLET BOX using OUTLET BOX
SCREWS (provided with OUTLET BOX).

3. While supporting CANOPY ASSEMBLY make

connections: black POWER CORD lead to hot (black)
supply lead; white POWER CORD lead to neutral
(white) supply lead. Green POWER CORD wire is a
ground wire and must be connected to grounding
terminal or ground lead inside OUTLET BOX. Use
WIRE NUTS (local hardware item). Push supply wires
and connections back into OUTLET BOX.

4. Tighten SET SCREW into STRAIN RELIEF BUSHING

to secure POWER CORD.

CAUTION: MAKE CERTAIN WIRES ARE NOT

PINCHED BETWEEN PARTS.

5. Place STUD through hole in CANOPY and thread

ADJUSTING COLLAR onto STUD securing CANOPY
ASSEMBLY against ceiling.

POWERHEAD INSTALLATION:

1. Remove DOOR from POWERHEAD by removing

screw (labled open) in top mounting plate. Pull 
door directly away from powerhead.

2. Height Adjustment: To raise fixture, push CABLE

down into HANGER FITTING. If necessary, push
excess POWERCORD down into POWERHEAD.
(Make certain CABLE does not interfere with internal
wiring or components, both POWERCORD and
CABLE may be cut inside POWERHEAD.) To lower
fixture, push down on PLUNGER and allow fixture to
drop to desired height.

3. If necessary, cut excess CABLE from inside

POWERHEAD.

4. Using wire nuts (local hardware item) wire fixture:

Black fixture lead to hot (black) POWERCORD lead;
white fixture lead to neutral (white) POWERCORD
lead. Attach green ground wire from BOTTOM PLATE
to green ground wire from POWERCORD and ballast
(if supplied).

5.

Reinstall door and secure in place by tightening SCREW
through TOP MOUNTING PLATE.

6. Install recommended lamp(s).

CAUTION: MAXIMUM WATTAGE AS MARKED ON

FIXTURE MUST NOT BE EXCEEDED.

REFLECTOR INSTALLATION:

1. To secure REFLECTOR to SPACER NECK, position

MOUNTING SCREWS through KEYSLOTS and twist
REFLECTOR counter-clockwise. Secure REFLECTOR
in position by tightening MOUNTING SCREWS.

INSTRUCTION SHEET FOR ASSEMBLY AND INSTALLATION OF 9” PENDALYTE

SERIES

MOUNTING SCREW

CABLE

PLUNGER

HANGER
FITTING

POWERHEAD

OUTLET BOX

SET SCREW

COLLAR

DOOR

POWERCORD

SCREW

TOP MOUNTING 
PLATE

STRAIN RELIEF 
BRUSHING

LIGHTOLIER a GENLYTE THOMAS company.

631 Airport Road, Fall River, MA  02720

OUTLET BOX SCREW

CABLE

FIG. 1

Reviews: