a fuse of the same type and electrical specifications!
l
Due to safety reasons, it is prohibited to make unauthorized modifications to the
unit.
Important: Never look directly into the light source! Don
’
t use the effect in the
presence of persons suffering from epilepsy.
Mounting and Installation
Important: Fixtures must be installed by a Qualified electrician in accordance with
all national and local electrical and construction codes and regulations.
Overhead Rigging
l
For overhead installation, the fixture must be always secured with a safety wire
that can bear at least 10 times the weight of the fixture.
l
Make sure the area below the installation is free from unwanted persons during
rigging, de-rigging and servicing.
l
Locate the fixture in a well ventilated spot, far away from any flammable materials
and/or liquids. The fixture must be fixed at least 50cm from surrounding walls.
l
The device must be installed out of reach of people where persons may walk by
or be seated.
l
Fixture installation must always be secured with a secondary safety attachment,
such as an appropriate safety cable.
l
Always use and install the supplied safety cable as a safe cable as safety measure
to prevent accidental damage and /or injury in the event the clamp fails.
l
The fixture should be well fixed, a free-swinging mounting is dangerous and may
not be considered!
Clamp Mounting:
The LED moving head provides a unique mounting bracket assembly that integrates
the bottom of the base, the included ‘omega bracket’ (see the following pic) and the
safety cable rigging point in one unit. When mounting this fixture to truss be sure to
sere to secure an appropriately rated clamp to the included omega bracket using a
M10 screw fitted through the center hole of the ‘omega bracket’. As an added safety
measure be sure to attached at least one properly rated safety cable to the fixture
using on of the safety cable rigging point integrated in the base assembly.
