SHOE BOX/WALL PACK SCREW-IN RETROFIT LAMP
INSTALLATION AND USERS GUIDE
INSTALLATION INSTRUCTIONS - SENSOR
1) Clean the lens of the luminaire
2) Remove the protective layer from the double stick foam tape on the sensor housing
3) Place the sensor on the lens in a corner close to the hinge and away from the
socket
4) Connect sensor wires to lamp at sensor port
5) Remove protective cover over LED array.
6) Turn on electrical power to the luminaire and verify proper operation.
11/25/2019
SENSOR PORT
USING REMOTE TO CHANGE PROGRAMING
•
Default settings: 100% Sensitivity, Disable Daylight Sensor, 90 Second Hold Time, 5 min Twilight Time, and 30% Twilight
Level
MAIN CONTROLS
•
On/Off
–
permanent on/off,
sensor disabled
•
Dim
–
press to adjust up/down
•
Auto
–
activate the sensor to last
settings
•
Reset
–
default settings
SENSITIVITY
•
100% is 8M (25 ft)
DAYLIGHT SENSOR
•
Turns lamp on/off at
certain lux level
HOLD TIME
•
Length of time at 100% when
motion sensor activated
TWILIGHT TIME (DIM TIME)
•
Lengths of time lamp
stays dimmed before
turning off
TWILIGHT LEVEL (DIM LEVEL)
•
% of light output when dimmed
LED-8090MXX-G4-OCC & LED-8090MXXC-G4-OCC