Liftup North America, Inc. | 14928 Casey Rd | Tampa, FL 33264 | T: +1 844 543 8878 | M: [email protected] | www.liftup.us
33
USER MANUAL
–
RAIZER® II
–
US VERSION 03.02
12.4
Pairing the transmitter and the receiver (remote control)
1.
The Raizer battery must be fully charged, see section 11.
2.
The Raizer must be switched off either using the on/off button or await the Raizer switching
off automatically after 10 minutes without activity.
3.
Press the UP (
↑
) and DOWN (
↓
) arrows of the remote control at the same time and keep
them pressed for approx. 5 seconds until the control LED on the remote control begins to
flash slowly. The remote control is now in installation mode for 2 minutes.
4.
Within these 2 minutes, switch on the lifting chair you require paired/associated with the
remote control by pressing the UP/DOWN (
↑/↓
) arrows on the side of the chair simul-
taneously.
5.
The control LED on the remote control is paired/associated with the lifting chair when it
stops flashing.
6.
Test the system to make sure that the pairing has been performed correctly; if not, repeat
steps 1-5 above.
Resetting the transmitter and the receiver:
To reset a remote control so that it is no longer paired/associated with the Raizer, do the
following:
1.
Press the UP (
↑
) and DOWN (
↓
) arrows at the same time and keep them pressed down
for approx. 5 seconds until the control LED begins to flash slowly. The remote control is
now in installation mode for 2 minutes.
2.
Within the 2 minutes, perform the following sequence:
Press: UP (
↑
), UP (
↑
), DOWN (
↓
), DOWN (
↓
), UP (
↑
), DOWN (
↓
), UP (
↑
), DOWN (
↓
)
When the control LED starts to flash quickly, the remote control is no longer associated/paired
with the Raizer.
Alternatively:
If the remote control is open, you may push
“reset” to res
tore the initial state.