INSTALLATION & SERVICE MANUAL – FLEXSTEP V2– UK VERSION
1.7
Liftup A/S
Hagensvej 21| DK-9530 Støvring | Denmark |
T:
+45 96 86 30 20 |
M:
[email protected] | www.liftup.dk | CVR DK-1015 3964
51
7.6
Automatic ramp/roll-off protection
The automatic ramp/roll-off protection is driven by an electric motor inside the steel tube. The
motor also drives the mechanical lock inside the tube. The lock ensures that no one or nothing
rolls off the lifting platform during motion.
Maintenance/Repair/Replacement:
1.
Unscrew the two screws holding the mounting bracket (A) for the ramp tube, and
remove gently. Beware of the wires connecting to the motor!
2.
Gently pull out the lock assembly from the tube (B & F). If the lock pawl (F) is out,
push it in with a finger. If the lock assembly is tight, use a screw to retract it from
the tube. The lock pawl is spring loaded - be careful!
3.
Gently pull out the cam disc and spring from the tube (C).
4.
Unscrew the screw holding the motor flange (D).
5.
Pull out the motor assembly. Be careful with the cable for the motor!
6.
When attaching the lock assembly, the lock pawl (F) should point towards the micro
switch (G).
7.
Micro switch for ramp lock.
Ramp part numbers
Lifting
platform
Ramp types
Pipe for ramp
Width
steps >120mm
steps >140mm
steps >175mm
Indoor Outdoor
700 mm
103318
103317
103316
103315
103379
800 mm
103245
103244
103140
103139
103377
900 mm
103242
103241
102573
102538
103226
1000 mm
103310
103309
103135
103134
103364
