Lift-Rite,
Tel:
Toll Free from USA: 1-800-558-6012, Greene, NY 13778, Publication Number 1234959D ©2022 Dated 14 Sep 2022
16
Summing
The indicator offers the possibility to add weighings and show the total weight. When a tare weight
is active, the net weight is added automatically.
•
Load the system with the weight that should be added.
•
Press the
key to add the weighed load to the total weight.
•
The display shows the message “ADDED” and after a short delay returns to the weighing
mode.
NOTE:
Note that no weight can be recorded twice. The system needs to be returned to the net
zero-range before another weight can be added up.
Press the
key for 3 seconds to check the subtotal.
•
The display shows the net total weight and the number of weights totaled so far repeatedly for
3 seconds.
•
If the
key is pressed during this period, the total is printed out (if option is installed) and
reset to 0.
•
If the “CE” key is pressed during this period, the total is reset but not printed out.
•
If no key is pressed during this period, the subtotal stays in memory and the system returns
to the weighing mode after 60 seconds.
Change Units
The system is set to start up in ‘lbs.’
instead of ‘kg’. However you may, at any time in the weighing
mode, change to the second unit (lb.
kg or kg
lb.).
•
Press the
key for 3 seconds.
•
The display shows the current weight in the new units for 5 seconds and then automatically
changes back to the start up units.
NOTE:
The same key is used to change from the piece counting mode back to the weighing mode.
