5
Lift-Rite, 22 South Canal Street, Greene, NY 13778,
Tel:
Toll Free from USA: 1-800-558-6012 Publication Number 1314694/001B ©2020
Dated 31 Jan 2020
TO ATTACH HANDLE TO PUMP UNIT
1. Remove 3 bolts (D611) from the handle bracket (D151).
2. Set handle (D610A, D610B or D610AS) on the bracket (D151), notice to allow the chain
(D612) and the adjusting bolts (D614) assembly to pass through the hole in the center of
the bracket (D151) and shaft (D153).
3. Insert the 3 bolts (D611) through the handle into the bracket (D151), then tighten them
securely.
4. Raise the lever plate (D132) and insert the adjusting bolt (D614) into the front slot, keeping
the adjusting nut (D615) on the underside of the lever plate (D132).
TO ADJUST RELEASE DEVICE
On the draw-bar of this pallet truck, you can find the control handle (D608 or D608S) which can be
adjusted in three positions:
If however they have been changed, you can adjust according to the following steps:
1. If the forks elevate while pumping in the
DRIVE
position, turn the adjusting nut (D615) on
the adjusting bolt (D614) or adjusting screw (D133) clockwise until pumping action does
not raise the forks and the
DRIVE
position functions properly.
2. If the forks lower while pumping in the
DRIVE
position, turn the nut (D615) or adjusting
screw (D133) counter-clockwise until the forks do not lower.
3. If the forks do not lower when the control handle (D608 or D608S) is in the
LOWER
position,
turn the nut (D615) or adjusting screw (D133) clockwise until raising the control handle
(D608 or D608S) lowers the forks. Then check the
DRIVE
position according to steps 1 and
2 to be sure
the nut (D615) or adjusting screw (D133) is in the proper position.
4. If the forks do not elevate while pumping in the
RAISE
position, turn the nut (D615) or
adjusting screw (D133) counter-clockwise until the forks elevate while pumping in the
RAISE
position. Then check the
LOWER
and
DRIVE
position according to steps 1, 2,
and 3.
Raise
Handle down
Drive
Handle in center position
Lower
Handle up, the lever moves back to the drive position when released.
Summary of Contents for Altra
Page 25: ......
