LifeSize Gateway-PRI, User Manual, Page: 36 / 196

28 LifeSize Gateway User Guide
LifeSize Gateway Unit Initial Configuration
10
At the Enter Default Router IP Address prompt, type the IP
address of the router associated with the segment in which the
unit will be installed and press
Enter .
Caution
Do not use leading zeros in the IP address.
11
At the Enter IP Mask <HEX> for default device prompt, type
the subnet mask as follows:
Convert the subnet mask IP address to hexadecimal
notation, type the hexadecimal number at the prompt,
and press
Enter .
For example, for the subnet mask 255.255.255.0 the
hexadecimal value you type is FFFFFF00.
Note
You can use the computer’s desktop calculator to convert the subnet
mask ID to hexadecimal notation.
If a subnet mask is not used, press Enter .
12 Allow the unit to complete the reboot process. A new emulator
session begins.
13
Close the terminal emulator session.
C
HANGING THE
C
ONFIGURATION
T
OOL
L
OGIN
P
ASSWORD
You can use the terminal emulator to change the default password of the default
login user before others can use the LifeSize Gateway interface.
Procedure
1
Start a terminal emulator session for the LifeSize Gateway
unit.
2 Press the RST button on the front panel of the LifeSize
Gateway unit.
After 60 seconds, a new terminal emulator session begins on the
computer monitor.