LifeSize Gateway-PRI, User Manual

Page: 120 / 196

112 LifeSize Gateway User Guide
Configuring Port Settings
Interface field. When DCE is selected in the Interface field,
the Terminal adapter option is set to Common and disabled.
6 In the Signaling protocol field, select a signaling protocol for
use in call setup from the following list:
RS-366— Carries signaling information only.
Data Triggered —Enables the LifeSize Gateway to
connect a call when it detects valid incoming data from
an endpoint on the serial network.
Manual Control —Enables an Administrator to
manually connect a call via the LifeSize Gateway web
user interface.
Different signaling protocols are available depending on the
interface and terminal adapter that you select, as shown in
Table 3-19 .
The Signaling protocol field is enabled only you select DTE in
the Interface field. The Signaling protocol field is set to
RS-366 and disabled when you select DCE in the Interface
field.
7 In the Incoming default bandwidth field, set the rate to which
the LifeSize Gateway forces the bandwidth of an incoming
call. Available only when
DCE is selected in the Interface
field.
8
(Optional) Click Connect Call/Disconnect Call to connect or
disconnect the specified call. Available only when Manual
Control is selected in the Signaling protocol field.
9 Click Reset .