9
10
1. Open the packed unit, and take out the guard packet
(as shown in the above image) along with the blade
2. Pick up the motor assembly along with the wall fan body.
3. Unscrew the 2 lock-nuts (as shown in the above image)
from the motor shaft & from the back cowl.
4. Fix the back guard and tighten the front lock-nut.
5. Slide the plastic blade on the motor shaft, and tighten the blade with the
lock-nut by rotating it in the anticlockwise direction.
6. Place the front guard and align the plastic ring with the front and back
guard and tighten the plastic ring screw.
7. The speed of the fan can be regulated by the speed control switch
fitted on the plastic stand by pressing the relevant buttons.
8. Modes: 0: stop
1: Low
2: Medium
3: High
1. To Change the speed of the fan, set the switch knob to the desired position.
2. There are three consecutive positions on the switch knob “1”, “2”, “3”
denoting the different speeds of the fan.
3. Fan runs at the maximum speed at position 3.
4. To tilt the fan, switch off the fan, hold the stand & tilt the fan either
upward or downwards as required.
5. Fan has an indexed tilt mechanism which does not require any tightening.
6. To access the oscillation mode, press the oscillation knob.
7. To stop the fan from oscillating, pull the oscillation knob upwards.
Automatically operated devices: To reduce the risk of injury, disconnect
from power supply before servicing.
Note: Place the fan on a firm, levelled surface. Insert the plug of the power
cord into any standard 220~240V,50Hz AC outlet.
OPERATING INSTRUCTIONS: