lifebreath.com
21
17
T
IMERS
Wireless 20/40/60 Minute Timer (99-DET02)
The timers may be installed onto a flush mounted electrical switch box or it may be surfaced mounted onto a wall.
Pairing
:
1.
Remove the battery from the back of the timer,
if installed.
2.
Press the ON/OFF Button on the main control
to turn it on.
3.
DXPL02
: Press the left and right buttons
( and RESET) simultaneously on the main
control. The screen will go blank, and the
wireless symbol will appear flashing on the
bottom right of the display. This indicates that
the main control is now in pairing mode.
4.
BC02, BC03, or BC04
: Press the left and right
buttons ( and or ) simultaneously on
the main control. The bottom row LEDs will
begin flashing. This indicates the main control is
now in pairing mode.
5.
Keep the timer within 16 in. of the main control
when pairing.
6.
Install the battery into the remote timer. The
four lights will immediately flash five times. The
red battery light will remain on for 12 seconds,
then the 40 minute status light will flash. The
20, 40, and 60 minute status lights will flash for
up to 30 seconds and then stop.
7.
Press the Power Button on the main control
to exit pairing mode.
8.
Press the Select Button on the timer to test that pairing was successful (figure A).
•
If the HRV initiates HIGH fan speed ventilation, pairing was successful.
•
If the HRV does not initiate HIGH fan speed ventilation, pairing was not successful. Un-pair the timer and return
to step 1 of the pairing procedure and restart the pairing process.
9.
Pair additional timers as necessary by repeating steps 1 through 8.
Un-pairing:
1.
Remove the battery from the back of the timer.
2.
Press and hold the Select Button on the front of the timer (figure A).
3.
While holding the Select Button, reinstall the battery in the timer. Continue holding the Select Button until the 20, 40,
and 60 minute status light begins flashing (this can take up to 30 seconds). The timer will now be unpaired with the
main control (figure A).
Installation:
1.
Separate the face plate from the back plate by firmly pulling apart (figure B).
2.
For mounting the main control without a Decora plate, break off top and bottom tabs (figure C).
3.
Place the back plate of the main control in the desired location on the wall and pencil mark the top and bottom screw
holes. Drill two 1/8" holes (figure C or D).
4.
Attach the back plate to the wall using the two supplied screws and anchors.
5.
Attach the face plate to the back plate (figure B).
Attention
•
The wireless timers and repeaters must be paired to the main control of the HRV. This process is called
“Pairing”. Multiple timers and repeaters can be paired to the main control.
Figure A
