EN20
EN21
Settings and adjustments
Settings and adjustments
Seat angle
The seat angle can be adjusted using the 2
gas springs and the operating lever near the
push-handle.
n
Press the operating levers to disengage
the gas springs.
n
Set the seat angle as required.
n
Release the operating levers.
Seat angle range
The seat angle range is 30°. It can be adjusted
from 0° to 30° and from -5° to 25°.
Required seat height
Seat angle
Position
42 cm
0˚ tot 30˚
G1
-5˚ tot 25˚
G2
≥ 44,5 cm
0˚ tot 30˚
G2
-5˚ tot 25˚
G3
N.B.:
seat angle range in combination
with the continuously adjustable backrest
angle adjuster: 0˚ to 22˚ or -5˚ to 17˚.
Armrests
The height, depth and width of the armrests
can be adjusted.
Adjusting the height
n
Unscrew the adjustable screw (A) at the
side of the armrest a couple of turns.
n
Set the armrest to the required height.
n
Retighten the star knob.
Adjusting the depth
n
Loosen the screws (B) fully (different hole
in armrest) or partially (using the slot).
n
Set the armrest to the required depth.
n
Retighten the socket screws.
G1
G2
G3
Adjusting the width
n
Loosen the screws (B) fully.
n
Set the armrest to the required width.
n
Tighten the screws in the required press-
in nut and slot of the armrest.
Side cushions
The height and depth of the side cushions
are adjustable.
Adjusting the depth
n
Loosen the socket screws (C).
n
Set the side cushions to the required
depth.
n
Retighten the socket screws.
Adjusting the height
n
Loosen the socket screws (D).
n
Set the side cushions to the required
height.
n
Retighten the socket screws.
Seat width
Follow the instructions on page 15 to adjust
the seat width.
Lower leg length
n
Loosen the socket screw (A) one turn.
n
S et the legrest to the required lower leg
length.
N.B.:
make sure the legrest is at least
5 cm off the floor.
n
Retighten the socket screw.
A
Right-hand push-handle (green sticker)
B
A
B
C
C
D
D