13
Lifa Air Oy Ltd.
• Vellamonkatu 30 B, 00550 Helsinki, Finland • Tel: +358 9 394 858
soaking. The brushes must be cleaned after every use in order to avoid cross-contamination. Wash
or spray the brushes with mild detergent and wipe clean with paper / disposable cloth.
The brush motor lubrication:
The pneumatic brush motor must be lubricated every day after working with it. Regular lubrication
enables the endurance of the motor. Pneumatic motor of Duct Control Cleaning robot must be
lubricated with light motor oil (*) after every day the robot has been used for brushing.
Before lubricating, tilt the robot “bottom up” so that the oil goes deeper to the connector/air hose.
The lubrication is done by spraying a small amount of oil in to one compressed air feed connector
on the back of Duct Control Cleaning Robot and then connecting compressed air to it so that the
motor is rotated for a few seconds to one direction only. This procedure is repeated for 2-3 times
and after this run the motor for one minute to clean the hose from excessive oil.
(*)Wurth Rost Off Plus, WD 40, CRC 5-56 or analog.
THE MAINTENANCE OF THE CAMERA
•
When winding the cable back to the reel after use always try to get all the twist out of the
cable; this is best done by hanging the whole cable in the air or releasing the cable to floor
in full length before winding it to the reel.
•
When winding the cable after use, wipe it clean with a soft cloth (microfiber, cotton, tissue or
similar) moistened with a mild detergent suitable for plastics.
•
Wipe the camera part, joystick box and the other parts with a soft cloth, too.
•
Carefully wipe clean the lens of camera and the LED lights of the Robot with a microfiber
cloth.
•
Check all the connection plugs, cables for any loosened screws or possible damages.
Spare parts
When ordering spare parts, always specify the size and type of the equipment (found from the CE-
plate located both in the robot body and control box).
NOTE!
Any repair needed must be carried out by the manufacturer or by a representative of the
manufacturer. We are not responsible for any service or repair carried out by a third party.
Warranty also expires if any other than Lifa accessories (brushes etc.) are used.
