28/79 Gebruikershandleiding / User Manual / Bedienungsanleitung
HAL200Li,
rev. 1.0: 09-02-20223
5. Operation
Read the safety aspects and operating instructions before use. If aspects are not clear to you, then
contact the manufacturer.
5.1 Using Hal200Li
1.
Check that the power feeder is correctly fitted and the switch is in the 'O' position.
2.
Place the K-150 in the direct vicinity of the place where you wish to smooth the concrete.
3.
Place the K-150 on the freshly poured concrete.
4.
Turn the speed control (Q) to the slowest position (towards you).
5.
Switch on the switch (P).
Figure 11: Operating elements.
6.
Increase the vibration speed with the speed control to the point that the chip begins to
slide by itself.
7.
Rotate the control handle to increase the angle of the trowel to the concrete surface.
Increase the angle so that the edge of the working profile protrudes above the concrete
surface on the operating rod side. This prevents the machine from digging itself in.
ALWAYS WEAR WORKING GLOVES WHEN INSTALLING AND USING THE MACHINE.
THERE IS A RISK OF CRUSHING WHEN INSTALLING THE MACHINE.
BE CAREFUL, WHEN THE MACHINE HAS BEEN USED, THE ALUMINIUM PARTS CAN
BE HOT.
