AS-2H-WP Installation Guide
10
Installation Instructions
Basic Installation
1.
Turn off power and disconnect the audio/video equipment by following the manufacturer’s instructions.
2.
Connect shielded Category 5E or greater twisted pair cable with the TIA/EIA-568B crimp pattern between the
transmitter (AS-2H-WP) and the HDBaseT receiver.
3.
If the HDBaseT receiver cannot provide power to the AS-2H-WP, connect the included power supply to the
24V DC power input of the device.
4.
Connect an HDMI cable between the display and the HDBaseT receiver per the manufacturer’s instructions.
5.
If a local display is part of the installation, connect an HDMI cable between the display and the HDMI output
port on the AS-2H-WP.
6.
Power on attached audio/video devices.
7.
Apply power to the HDBaseT receiver.
8.
If the HDBaseT receiver cannot provide power to the AS-2H-WP, connect the power supply going to the AS-
2H-WP to an AC outlet.
9.
Connect HDMI sources.
HDBaseT Cabling Requirements
For all HDBaseT cabling, the EIA/TIA-568B crimp pattern must be used on Category 6 or greater cable. In
areas with large amounts of electromagnetic (EM) or radio frequency (RF) interference, a shielded variety of
Category 5e or greater cable is recommended with shielded connectors on both ends of the selected cable.
TIA/EIA-568B
Orange/White
Orange
Green/White
Blue
Blue/White
Green
Brown/White
Brown
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
Pin 6
Pin 7
Pin 8
1
8
Summary of Contents for Intelix AS-2H-WP
Page 2: ......
