DL-SC41U-TX Installation Guide
14
The
CONTROL
menu allows you to route A/V signals from the video inputs to the HDMI and HDBaseT outputs of
the switcher and enable / disable auto switching mode.
To enable / disable auto switching mode, check the
ON/OFF
button in the
Auto Switching
menu. When auto
switching is disabled, the switcher must be switched manually by either using the front panel buttons, the
embedded web GUI or with the API. By default the
DL-SCU41-TX
is set to auto switching mode and follows the
‘first in last out’ method. To use
5V
HDMI or A/V
Signal Detection
for auto switching mode, check the desired
button in the
Auto Switching
menu, the setting will take immediately. By default auto switching is set to 5V HDMI
for the auto switching trigger.
When auto switching mode is disabled, the video route for either HDMI and HDBT outputs can be routed
manually by checking the input buttons that corresponds with the output in the web GUI.
TX HDMI OUT
refers
to the DL-SC41U-TX,
RX HDMI OUT
refers to the optional DL-SCU-RX HDBaseT receiver.
When auto switching mode is enabled, the selected AV input will be routed to both outputs except for the HDMI
input on the optional DL-SCU-RX HDBaseT receiver which can only be routed to the HDBaseT receiver HDMI
output.
A/V Switching