LI-COR LI7200RS, Instruction Manual

Page: 76 / 226

Section 3. Operation
Connect with an LI-7700
Click on the button in the
Site Setup > LI-7700
dialog box or the LI-7700 but-
ton in the dashboard to connect to an LI-7700 CH
4
analyzer.
The LI-7700 tab displays a list of LI-7700 instruments available on the network
(same subnet as computer). Select an LI-7700 from the list or enter an IP address
in the ‘LI-7700 Hostname’ field (networked device on different subnet mask as com-
puter) and click
Connect
. Click
Apply
or
OK
. When you start logging data with the
LI-7550 via USB, the chosen data values for the LI-7700 will be logged, as well.
IMPORTANT: To synchronize the clocks of the LI-7500DS, LI-7500A/RS or LI-
7200/RS and the LI-7700, be sure to configure the PTP time setting in the LI-
7700 to
Slave
or
Automatic
.
Enter analyzer information
Here you specify the separation between the sonic anemometer and the LI-7700
sample volume.
Important: At least one separation must be different from 0. Values are meas-
ured at the site and are relative to the sonic anemometer. Entering wrong values
will result in incorrect flux calculations.
3-34 LI-7200RS Enclosed CO₂/H₂O Analyzer