LI-COR LI-7200x, Instruction Manual

Page: 37 / 64

Configure Sutron biomet system communication
Here you will configure the network settings of the Biomet system and establish the
data connection to the LI-7200x and LI-7500x. The steps in this section describe how
to log biomet data in
.ghg
files for processing in EddyPro software or with the
SmartFlux System.
This section assumes that you have completed all the required steps in Configuring
the communication system on page 3-1 and that you have verified that the satellite ter-
minal can connect with the Internet.
Note: Prior to adding the Biomet station, be sure to complete the steps in Con-
figure LI-7500x or LI-7200x eddy covariance system communication on page 4-2.
1
Connect the datalogger to your PC.
You probably have done this already, but if not, connect the Sutron Datalogger to
your PC Ethernet terminal either directly or through an Ethernet switch.
2 Launch the
XTerm Software
that is provided with the Sutron Datalogger.
Select the
TCPIP
radio button, then click
Detect
. Select the Sutron from the list
click, and click
OK
to connect. You may need to type in the IP address if the soft-
ware cannot detect the datalogger (169.254.100.100 by default).
Section 4. Configuring the eddy covariance system
4-7 Configure Sutron biomet system communication