Operation Manual of Elevating Work Platform
30
7.12 Using the Safety Prop
1) Elevate the platform a specified height above
the ground (for elevation height, refer to the
following table).
Model
Height (m)
SS0407E
2.4
SS0507E
AS0607
AS0607E
AS0612
2.5
AS0612E
SS0607E
2.77
AS0607W
AS0607WE
AS0608
3.2
AS0608E
AS0808
AS0808E
AS0812
AS0812E
AS1012
AS1012E
AS1212
4
AS1212E
AS1413
AS1413E
2) Lift the safety prop, move it to the center of
the scissor cross tube and rotate it upward
until it is vertical.
3) Lower the platform height until the safety
prop completely contacts the shaft tube.
Keep the platform away from the movable
parts during the lowering process.
△
!
Danger
Do not carry any load in the platform
when the safety prop is being used. No
long time (8 hours) to use safety prop in
empty state.
7.13 How to Stow the
Guardrail
.On models SS0407E/SS0507E/ SS0607E/
AS0607/ AS0607E/ AS0607W/AS0607WE/
AS0608/AS0608E/AS0808/AS0808E , the
platform guardrail system consists of a folding
guardrail on an extended platform and a
folding guardrail on the main platform.
1) Fully lower the platform and lock it into the
extended platform.
2) Remove the platform controller.
3) Remove the M-shaped fixed seat between
the guardrails of the main platform and the
extended platform from the inside of the
platform and place it in the platform.
4) Remove the two retaining pins at the front of
the extended platform from the inside of the
main platform.
5) Fold the front guardrail of the extended
platform inward. Do not place your hands in
places where there may be a pinch point. At
the same time, prevent the left and right
guardrails of the extended platform from
tilting over.
6) Install the two retaining pins which were
removed back to the guardrail on each side.
