LG WM2277H Series, Training Manual

Page: 32 / 82

WM2277 WASHER PAGE 33 of 84 TRAINING MANUAL
TEST MODE
The washer must be empty and OFF to enter the test mode.
1. Press and hold SPIN SPEED and SOIL LEVEL .
2. Press POWER .
3. Press START/PAUSE to cycle through the test modes. (See chart.)
# of times
the START button
is pressed
Event Display
0
All lamps on, door locked XX:XX (see below)
1 Tumble clockwise rpm (40~50)
2 Low speed spin rpm
3 High speed spin rpm
4 Prewash inlet valve opens water level freq (25 ~ 65)
5 Main wash valve opens water level freq (25 ~ 65)
6 Hot inlet valve opens water level freq (25 ~ 65)
7 Bleach inlet valve opens water level freq (25 ~ 65)
8 Tumble clockwise rpm (40~50)
9 Heater on for 3 seconds water temperature ° C
10 Circulation pump runs water level freq (25 ~ 65)
11 Drain pump runs water level freq (25 ~ 65)
12 Power off, unlock door All lamps off
The EPROM check sum will be displayed at the beginning of the test. The
checksum will indicate the model number and the program on the main board.
1F:61 WM2677H*M
CHECK THE WATER LEVEL FREQUENCY (In QC Test Mode)
The display will show a number (usually between 25 and 65) to indicate the water
level frequency. In QC Test Mode, multiply the 2-digit readout by 0.1 and add 20
to determine the frequency. For example, the display shows 65 at steps 4, 5, 6, 7,
10, and 11 in the test mode. Multiply 65 by 0.1 to get 6.5, add 20 to get 26.5 kH
z
,
which is the water level frequency.