n
o
it
u
l
o
S
e
s
u
a
C
e
l
b
i
s
s
o
P
m
o
t
p
m
y
S
• Water supply is not adequate in area
• Water supply taps are not completely open.
• Water inlet hose(s) are kinked.
• The filter of the inlet hose(s) are clogged.
• Drain hose is kinked or clogged.
• The drain filter is clogged.
• Load is too small.
• Load is out of balance.
• The appliance has an unbalance detection
and correction system. If individual heavy
articles are loaded (ex. bath mat, both robe,
etc.), this system may stop spinning or even
interrupt the spin cycle altogether.
• If the laundry is still too wet at the end of the
cycle, add smaller articles of laundry to
balance the load and repeat the spin cycle.
• Is the door opened or not
completely closed?
• Water overfills due to the faulty water
valve.
• Water level sensor has malfunctioned.
• Over load in motor.
• Water leaks
• The washer experienced a power failure.
Check another tap in the house.
Fully open tap.
Straighten hose(s).
Check the filter of the inlet hose(s).
Clean and straighten the drain hose.
Clean the drain filter.
For more detailed information,
please refer to “
Cleaning the drain pump filter
”
Add 1 or 2 similar items to help
balance the load.
Rearrange load to allow proper
spinning
Close the door completely.
If “ ”is not released, call for service.
Unplug the power plug and call for service.
Close the water tap.
Unplug the power plug.
Call for service.
Call for service.
Restart the cycle.
4
1
2
3
5
7
1
2
3
4
Schraubenschlüssel
6
60 - 100 cm
@
N
Adjustable feet
Adjustable feet
CAUTION
The appliance is not intended for use by young children or infirm persons without supervision.
Young Children should be supervised to ensure that they do not play with appliance.
Owner
‘
s Manual
WD-14030FDS
Safety instructions for use
Read all instructions and explanations of the installation before use. Follow the instructions carefully. Keep the ope-
rating instructions handy for later use. If the appliance is sold or passed on then ensure that the new owner always
receives these operating instructions. The following warnings must be strictly observed for safety reasons. They must
be read before installing the appliance and putting it into operation.
• Intended use: This appliance has been designed exclusively for use in dry-interior households. Use the appliance
only with cold drinking water and only for washing textiles with washing detergents designed for washing machi-
nes. Every other use is improper and may lead to injuries, whereby the liability of the manufacturer will cease.
• This appliance may only be used by adults. Do not allow children to touch the controls or to play with the product.
• Never modify the appliance on your own, as this is dangerous.
• This appliance is heavy. Transporting with care.
• Remove all packaging and transport bolts before using the appliance. Otherwise serious damage may result.
• All installation work must be carried out by a qualified fitter or technician.
• Have electrical connections done by a qualified electrician.
• Never place the appliance on the power cord.
• If the appliance is placed on a carpet then place the feet so that air can circulate underneath the appliance.
• Always unplug the machine and turn off the water supply after use. Disconnect appliance by pulling only the plug
- never disconnect by pulling the power cord. Never touch the plug with wet fingers or hands.
• Do not overload the appliance.
• Wash only machine-washable textiles. If you have doubts regarding this, then observe the markings on the label.
• Never place electrical heaters, candles etc. in the vicinity of the appliance. They could cause the appliance to
ignite or parts to warp.
• Protect the appliance from wet and damp. Otherwise, there is danger of electric shock and fire.
• Connect the appliance to a suitable wall socket for 220V. Never use an extension cord or double adapter.
• Empty all pockets. Hard or sharp objects such as coins, needles, nails, screws or stones may cause serious
damage.
Unbalanced mass may create heavy vibrations. If heavy vibrations remain also without load, call for an authorized
customer service.
• Do not wash or dry articles that have been cleaned in, washed in, soaked in, or dabbed with combustible or
explosive substances (such as wax, oil, paint, gasoline, degreasers, dry-cleaning solvents, kerosene, etc.). This
may result in fire or explosion.
• Never insert products coated with mineral oils (e.g. nylon coating, plastic belts, etc. ) into the machine. If a stain
remover has been used then make sure that the solvent has been carefully washed out before inserting the
clothes into the appliance. Oil may remain in the tub after a whole cycle resulting in fire during drying. So, do not
load oily clothes.
• Do not operate the appliance at locations where flammable substances are present such as oil, benzene or highly
inflammable gas. Such materials may cause fire or explosion. Never use combustible detergents.
• Only add the prescribed amount of softener. Excessive amounts may damage the clothes.
• After washing, keep the drum door open to protect the door seal.
• Make sure that all water has run off before opening the door. Never open the door if water still remains. Danger
of scalding.
• Animals and children may get into the washing machine. So always check the appliance before using it.
• During washing, the glass door becomes very hot. Keep children away from the appliance when in operation.
• Never try to repair the machine yourself. Incorrect repairs may result in injuries and/or serious defects to the
machine.
• The product should be serviced and repaired only by the authorised customer service using original replacement
parts.
• When disposing of your old machine, the power cable must be capped and the door lock must be made unusable
in order to protect children.
• When placing on a carpeted floor, make sure that the opening in the socket is not blocked.
• If the appliance has been under water then contact the customer service. There is danger of electric shock and
fire.
• The cover cup of the filter as well as the dispenser drawer may not be opened during the operation.
• Keep all washing powder and detergents away from children. Danger of poisoning
Before use please read carefully the safety instructions!
Thank you for buying an LG fully automatic washing machine.
Please read this owner‘s manual carefully, it provides instructions on safe installation, use and maintenance.
Keep it handy for future reference of this machine. Make a note of the model and serial numbers of your washing machine.
Remove Packaging
Requirements for installation site
Transit bolts
Electrical connection
Connecting water supply hose
• The appliance is fitted with transit bolts to prevent internal
damage during transport.
Be careful, heavy load!
• Packing and all transit bolts must be removed before using
the washing machine.
• When unpacking the base, be sure to remove the additional
packing support in the middle of the base packing.
Store original packing for future move.
Dispose of packing material according to local regulations.
Unscrew the 4 bolts
using the spanner
supplied.
Level floor:
Permissible floor gradient under entire washing machine
is 1˚ .
Power socket:
Must be within 100 cm of either side of location of
washing machine. Do not overload the socket with more than one
appliance.
Additional Clearance:
For wall, floor and door space is needed.
(10cm: rear / 2cm:right & left side). Do not place or store laundry pro-
ducts on top of the washing machine at any times. They can damage
the finish or controls of the machine.
• Two rubber seals are supplied with the water inlet hoses. They are used for preventing water leaks.
• Make sure the connection to taps is tight enough.
• Periodically check the condition of the hose and replace the hose if necessary.
• Make sure that there is no kink on the hose and that it is not crushed.
Water supply pressure must be between 1.0-10 bar (100kPa~1000kPa)
Don’t strip or crossthread when connecting inlet hose to the valve.
If the water supply pressure is more than 1000kPa, a decompression
device should be installed.
• The drain hose should not be placed higher than 100 cm above the floor.
• Proper securing of the drain hose will protect the floor from damage due to any water leakage.
• If the drain hose is too long do not force back into the washing machine. This will cause unusual noise.
• Proper level-adjustment of the washing ma-
chine prevents excessive noise and vibration.
Install the appliance on a solid and level floor
surface, preferably in a corner of the room.
• If the floor is uneven, adjust feet as required.
(Do not insert pieces of wood etc. under the
feet). Make sure that all four feet are stable
and resting on the floor. Then check that
the appliance is perfectly level. (Use a spirit
level).
Safety instuctions for the installation
CAUTION about positioning the appliance
CAUTION about the power cord
CAUTION about location and moving
CAUTION about the floor surface
ℓ
ℓ
Rattling and clanking noise
Extraneous objects such as coins or safety pins maybe in drum or pump.
Thumping sound
Heavy wash loads may produce a thumping sound. This is usually normal.
Vibrating noise
Have all transit bolts and packing been removed?
Water leaks.
Check and tighten hose connections. Unclog drain pipe.
Contact plumber if necessary.
Excessive suds
Too much detergent or unsuitable detergent.
Washing machine does not start
Power cord may not be plugged in or connection may be loose.
Washing machine won’t spin
Check that the door is firmly shut.
Door does not open
Once started, the door can not be opened for safety reasons.
Wait one or two minutes before opening the door to allow the electric
locking mechanism time to release.
Troubleshooting
Level adjustment
To prevent internal dama-
ge during transport, the
special 4 bolts are locked.
If they are not removed, it
may cause heavy vibrati-
on, noise and machine to
malfunction.
Installation of drain hose
Technical Specification
If after completing connection water leaks from the hose, repeat the same steps. Use the most conventional
type of tap for water supply. In case the faucet is square or too big, remove the spacing ring before inserting
the tap into the adaptor.
i
i
The hose supplied with the machine must be used. Old hoses may not be reused
Close the holes with
the caps supplied.
Remove the 4 bolts
along with the rubber
bungs by slightly
twisting the bung.
P/No. :MFL61988476
