LG T2518VSAB, Owner'S Manual

Page: 13 / 40

13
EN
3
Push the adapter onto the end of the tap
so that the rubber seal forms a watertight
connection. Tighten the four fixing screws.
4
Push the supply hose vertically upwards
so that the rubber seal within the hose can
adhere completely to the tap and then tighten
it by screwing it to the right.
Plate Plate
Supply Supply
hose hose
Connecting One Touch Type
Hose to Tap Without Thread
1
Unscrew the adapter ring plate and loose the
four fixing screws.
Ring plate Ring plate
2
Remove the guide plate if the tap is too large
to fit the adapter.
Guide plate Guide plate
3
Push the adapter onto the end of the tap
so that the rubber seal forms a watertight
connection. Tighten the four fixing screws and
the adapter ring plate.
4
Pull the connector latch plate down, push the
supply hose onto the adapter, and release the
connector latch plate. Make sure the adapter
locks into place.
Latch plate Latch plate
NOTE
•
After connecting the supply hose to the water
tap, turn on the water tap to flush out foreign
substances (dirt, sand, sawdust, and etc.) in the
water lines. Let the water drain into a bucket,
and check the water temperature.