35
TrOuBLEShOOTiNg
Before calling for service (cont.)
Problem
Possible Causes
Solutions
Steam doesn’t
generate but no error
code is shown.
• Water level error.
• Unplug dryer and call for service.
Garments still
wrinkled after
STEAM FRESH™.
• Too many or too different types of garments
in dryer.
• Small loads of 1 to 5 items work best.
• Load fewer garments. Load similar-type garments.
There are no creases
left on garment after
STEAM FRESH™
• The function of this cycle is to remove
wrinkles from fabric.
• Use an iron to make creases.
Garments have
static after REDUCE
STATIC.
• This is normal.
• Depends on individual moisture level in skin.
Garments are too
damp or too dry after
REDUCE STATIC.
• Correct drying options not selected.
• Select load weight manually before starting REDUCE STATIC option.
Garments are not
uniformly damp after
EASY IRON.
• This is normal.
• Depends on the amount or type of garments.
Water drips from door
during Steam Cycle.
• This is normal.
• This is steam condensation on door surface.
Steam is not visible
during Steam Cycle.
• This is normal.
• Steam vapor is difficult to see when the door is closed.
Drum does not turn
during Steam Cycle.
• This is normal.
• The drum is turned off so that the steam vapor remains in the drum.
Cannot see steam
vapor at the
beginning of cycle.
• This is normal.
• Steam is released at different stages of the cycle for each option.
The display shows.
• MORE TIME button pressed.
• Pressing the MORE TIME button several times will set the cycle for a large load
such as a comforter.
Odors remain in
clothing after
STEAMFRESH™.
• STEAMFRESH™ did not remove odor
completely.
• Fabrics containing strong odors should be washed in a normal cycle.
FLOW SENSE™
indicator light is on
during the drying
cycle
• Ductwork is too long or has too many turns/
restrictions.
• Significant blockage of the ductwork due to
lint buildup or debris.
• The appliance has detected a restriction in
the external dryer venting.
• Install a shorter or straighter duct run. See the Installation Instructions.
• Ductwork should be checked/cleaned soon.
Dryer can be used in this condition, but drying times may be longer.
• If exhaust restrictions are sensed by the FLOW SENSE™ system, the indicator
will remain on for two hours after the end of the cycle. Opening the door or
pressing the POWER button will turn off the display.
The display shows
“d90”, “d95”
• The duct work is about 90%-95% blocked.
(“d90” or “d95” error code displayed 2 hours
only)
• House exhaust system blocked.
•
Do not use the dryer until the exhaust system has been cleaned and/or
repaired. Using the dryer with a severely restricted exhaust is dangerous and could
result in a fire or other property damage.
• Check the outside dryer vent while the dryer is operating to make sure there is
strong airflow.
• If the exhaust system is extremely long, have it repaired or rerouted.
• Keep the area around the dryer clean and free of clutter.
• Check vent hood for damage or lint clogging.
• Make sure the area around the vent hood is clear.
