42
ENGLISH
Troubleshooting
PCS500R Setup
The following sections provide basic troubleshooting information for the PCS500R.
Equipment Setup Review
•
Make sure all connectors and connections are tight and secure on all entertainment system components.
•
Check the PCS500R LED. Under standard operating conditions, i.e., when the PCS500R is booted and operating
normally, the PWR (Power) LED on the PCS500R front panel is continuously lit green. If there is a hardware
fault, the PWR LED will turn and stay red.
Note
: When power is first applied to the PCS500R, the PWR LED initially flashes red and then turns green
(blinking during boot-up).
Network Setup
If the network is configured for DHCP but the PCS500R has not been assigned an IP address, i.e., the Ctrl IP field
in the PCS500R System Information display is blank:
1 Check the Control Port connector on the rear panel of the PCS500R. Make sure the cable connection is tight
and secure.
2 Observe the green LED on the Control Port. Once the PCS500R is connected to the network, the LED will be
lit continuously.
3 Contact the network administrator to verify the network status and check that the DHCP server is working
properly.
Summary of Contents for PCS500R Pro:Centric
Page 70: ......
