This device is to be serviced only by properly qualified service personnel.
Consult the Service Manual for proper service procedures to assure continued safety operation and for precautions
to be taken to avoid possible exposure to excessive microwave energy.
SAFETY PRECAUTIONS
2
PRECAUTIONS TO BE OBSERVED
BEFORE AND DURING SERVICING TO
AVOID POSSIBLE EXPOSURE TO
EXCESSIVE MICROWAVE ENERGY
A) Do not operate or allow the oven to be operated with the door open.
B) Make the following safety checks on all ovens to be serviced before activating the magnetron or other
microwave source, and make repairs as necessary; (1) Interlock operation, (2) proper door closing,
(3) seal and sealing surfaces (arcing, wear, and other damage), (4) damage to or loosening of hinges
and latches, (5) evidence of dropping or abuse.
C) Before turning on microwave power for any service test or inspection within the microwave generating com-
partments, check the magnetron, wave guide or transmission line, and cavity for proper alignment, integrity,
and connections.
D) Any defective or misadjusted components in the interlock, monitor, door seal, and microwave generation
and transmission systems shall be repaired, replaced, or adjusted by procedures described in this manual
before the oven is released to the owner.
E) A microwave leakage check should be performed on each oven prior to release to the owner.
CAUTION
MICROWAVE RADIATION
SPECIAL FUNCTION
Auto Cancel Function:
If you don’t touch start key for 4 min. 15 sec after setting and power the oven display will be
changed to initial condition.
DO NOT BECOME EXPOSED TO RADIATION FROM THE MICROWAVE
GENERATOR OR OTHER PARTS CONDUCTING MICROWAVE ENERGY.
Summary of Contents for MH-794GS
Page 11: ...SCHEMATIC DIAGRAM 11 ...
Page 32: ...DOOR PARTS 32 13720D 13806D 13581A 14970A 14026A 13552A 13536A 15006A 13213A 14890A ...
Page 35: ...LATCH BOARD PARTS 35 43501A 466001 466003 466001 44510A 43500A WSZ085 ...
Page 37: ...BASE PLATE PARTS 37 56170D 647781 WTT030 63303R 63303L 948502 ...