ENGLISH
39
ANTENNA ISOLATOR INSTALLATION GUIDE
Unpacking and Exterior of antenna isolator
Connection method
Use this to install TV in a place where there is a voltage difference between GND of power and
GND of antenna signal. If there is a voltage difference between GND of power and GND of
antenna signal, the antenna contact might be heated and excessive heat might cause an accident.
You can improve the safety when watching TV by efficiently removing power voltage from TV
antenna. Avoid disconnecting the antenna Isolator after installation.
“Equipment connected to the protective earthing of the building installation through the mains
connection or through other equipment with a connection to protective earthing - and to a
cable distribution system using coaxial cable, may in some circumstances create a fire hazard.
Connection to a cable distribution system has therefore to be provided through a device providing
electrical isolation below a certain frequency range (galvanic isolator, see EN 60728-11)”
When applying the RF Isolator, a slight loss of signal sensitivity can occur.
1
Connect
Plug 1 with a signal cable.
2
Connect
Plug 2 with ANT input end on the back of TV.
y
Image shown may differ from your TV.
Isolator (Type A)
Isolator
TV
Cable / Antenna
Cable / Antenna
Isolator
Set Top Box
TV
Plug 2
Plug 2
Plug 1
Plug 1
Isolator (Type B)
or
or
ENGLISH
ANTENNA ISOLATOR INSTALLATION GUIDE
