LG LMV2031, Installation Instructions Manual

Page: 10 / 16

STEP 3: Prepare The Venting Blower
WALL-VENT
ING
INSTALLATION:
1. Remove one or two blower unit mounting screw(s) and one
or several blower plate mounting screw(s). Remove the
blower plate from the cabinet. See Figure 1
3
.
2. Carefully lift the blower unit out of the microwave oven.
3. Use side cutters or tin snips to cut and remove knockouts
B from Back plate. Discard knockouts. Be careful not to
distort the plate. See Figure 1
5
.
4. Reassemble the blower wire. See Figure 1
6
.
5.
Rotate and reinstall the blower unit so that the exhaust
ports face the rear
of the cabinet
and are aligned with the
rear cut-outs. See Figures 1
7
& 1
8
.
6 . Reattach the blower plate to microwave oven so the exhaust
ports and blower plate opening are aligned. Attach with one
blower unit mounting screw and then one or several blower
plate mounting screw(s). See Figure 1
9
.
7 .
Insert the tabs on each side of the damper into the holes
at the inside rear of the adaptor.
Attach the exhaust adaptor to the
back plate wall side.
Push in securely until it is past the
top locking tabs
and in the lower locking tabs. Take care to
assure
the damper hinge is installed so that it is at the top
and that the damper swings freely.
See Figure 20 .
Figure 1
3
Blower Plate
Mounting Screw
Blower Plate
Back Plate
Blower Unit
Mounting Screw
Blower Unit
Parts B
Figure 1
4
Blower
Unit
Exhaust Ports
Figure 1
5
Figure 1
6
Figure 1
8
Blower Plate
Mounting Screw
Blower Plate
Back Plate
Blower Unit
Exhaust Ports
Blower Unit
Blower Unit
Mounting Screw
Figure 1
7
Exhaust
Ports
– 1
0
–
Slide exhaust
adaptor into
guides on
rear panel.
Exhaust Adaptor
Damper
(hinge side up)
Locking
Tabs
Guides
Figure
1 9
See Figure
14
.
Parts B
Knockouts Parts B
Figure
2 0
or