LG GoldStar MM-1041XP, Owner'S Manual

Page: 16 / 21

15
User Options
Follow the instructions below to customized the
microwave oven’s operation. End-of-cycle signal,
maximum heating time and other options can be changed
to meeting your cooking needs.
1.
Open oven door.
• If door is closed or
RESET pad is pressed before
finishing programming sequence, oven exits
programming mode.
2. Press and hold pad 2 for approximately 5 seconds.
• After 5 seconds, signal sounds. Display shows
“OPTION”.
3. Press number pad that matches desired option.
• “OP” represents optional program mode, first
number represents option number and second
number represents functions currently selected for
option.
4. Press START pad to advance to next option. See
table for options.
5. Press number pad (0,1-3) to change option.
6. Press START pad to save changes.
• Repeat steps 4-6 to change additional options.
7. Press STOP/RESET pad or close oven door to exit
programming mode.
OP 11
Optional Program
Indicator Pad
Number Option
Selected
Numbered Pads Display Options ( ) = Factory Setting
1
End of Cycle Beep
OP:10
OP:11
OP:12
3 second continuous beep
(Continuous Beep until door is opened)
5 beeps bursts until door is opened
2
Speaker Volume
OP:20
OP:21
OP:22
OP:23
Eliminates beep
Sets volume to low; 60-70dB
Sets volume to medium; 70-80dB
(Sets volume to high; 80-90dB)
3
Key Beep
OP:30
OP:31
Prevents signal when pad is pressed.
(Allows signal when pad is pressed.)
4
Keyboard Enable
Window
OP:40
OP:41
(30 seconds after oven door is opened, keyboard disabled)
2 minutes after oven door is opened, keyboard disabled
5
Add Time during
Heating
OP:50
OP:51
(Prevents adding heating time while oven is heating.)
Allows adding heating time while oven is heating.
6
Reset Door Open
OP:60
OP:61
(Cancels heating time count down after door is opened during
cycle.)
Allows oven to resume heating time countdown after door is
opened during cycle.
7
Maximum Heating
Time
OP:70
OP:71
Allows 10 minutes of heating time.
(Allows 60 minutes of heating time.)
8
Manual Operation
OP:80
OP:81
Allows use of preprogrammed pads only.
(Allows use of manual time entry and preprogrammed pads.)