CHAPTER 6 COMMUNICATION FUNCTION
6-22
6.1.7 High speed link parameter setting in KGLWIN
Profibus-DP master for MASTER-K also use a SyCon for Configuration setting and the setting
method is also same as GLOFA-GM. For MASTER-K,
it is required to set the high speed link
parameter after downloading the Configuration to master module
and high speed link
parameter selects the parameter from KGLWIN project screen and set the relevant items. The
setting procedure and the function of each item are as follows :
1) High speed link parameter setting in KGLWIN
If you select the parameter from the following project basic screen, the high speed link
parameter basic screen appears and you can select the relevant items.
KGLWIN Project basic screen
2) High speed link parameter select
A) Setting method
Select the relevant parameter from the basic screen as shown on the figure below and
enter into the parameter setting.
Parameter setting basic screen
②
Set ‘Link-
Enable’
①
When
parameter
window is open,
press “link1”
tab to set high
speed link
parameter.
③
Set the base
no. , the current
master module
is loaded, slot
no. and Pnet