15
INSTALLATION
ENGLISH
Connecting the Drain Hose to
the Mini Washer
The drain hose should not be placed higher than
100 cm
above the floor. Water in the appliance may
not drain or may drain slowly.
1
Insert the band clamp onto the drain hose
elbow. Pliers may be required to open the
clamp so it can be fitted to the rubber end of
the hose.
2
With the hose leading up from the elbow,
firmly insert the elbow onto the drain outlet on
the back of Mini Washer.
3
Adjust the band clamp with pliers to keep the
hose securely in place and prevent leaking.
Connecting the Drain
Connector
1
Insert the included band clamps on to the ends
of the two drain hoses.
2
Connect the drain hose of Main Washer and
Mini Washer to the drain connector.
3
Connect the drain hose to the drain spigot on
the laundry sink or bench top fitting.
CAUTION
• Adjust the band clamps to prevent the hoses
from coming loose or leaking. Failure to do so
could result in flooding. Use of the drain
connector helps avoid siphoning, odors, or
improper draining.
• Make sure the drain hoses are not kinked or
pinched. This is a potential cause of drainage
problems or noise.
NOTE
• Depending on the installation environment, you
may have to purchase a separate drain hose
connector. The connector supplied will suit a
standard laundry tub side drain hole.
Levelling the Appliance
Checking the Level
When pushing down the edges of the top plate
diagonally, the appliance should not move up and
down at all (check both directions).
• If the appliance rocks when pushing the top
plate of the appliance diagonally, adjust the feet
again.
• Check whether the appliance is perfectly level
after installation.
NOTE
• Timber or suspended type flooring may
contribute to excessive vibration and unbalance.
Reinforcement or bracing of the timber floor
may need to be considered to stop or reduce
excessive noise and vibration.
Adjusting and Levelling the
Feet
When installing the appliance, the appliance
should be aligned and perfectly level. If the
appliance is not aligned and level properly, the
global_main.book.book Page 15 Tuesday, March 23, 2021 3:42 PM
