17
INSTALLATION
ENGLISH
2
Check the opening of door and repeat if
necessary until the door opens and closes
properly.
Securing Dishwasher to Cabinet
Framework
1
Remove the 2 plastic caps from the mounting
bracket access holes.
2
Drive a wood screw (
Φ
4.5 x 12 mm) through
the mounting bracket and into the cabinet
frame.
3
Reinstall the plastic caps.
NOTE
• External water leakage could result if the
installation of the screws to the surrounding
timber cabinet is not done correctly.
• Please ensure that the height levelling of the
dishwasher is done by adjusting the feet before
installing the side cabinet securing screws.
Installing the Drain Hose
If the end of the drain hose does not fit to the drain
line, use a drain extension kit (optional) that is
resistant to heat and detergent.
• This should be available from a plumbing shop
or a hardware store.
Connection to the Waste Spigot
Check the waste spigot when initially installing. An
OE
error can occur when the waste spigot below
the sink is not drilled out properly. To connect the
drain hose, drill out at least a 15 mm diameter hole
in the waste spigot before connecting and
securing.
CAUTION
• Make sure that plastic debris is not remaining
inside of spigot after it has been drilled out.
• Do not attempt to open the waste hole with a
screwdriver and hammer. This will induce debris
to become stuck and cause a malfunction.
• Caution should be taken when passing hoses
through Cabinetry holes as they may have sharp
edges and could damage the hoses. Smooth or
sand edges to avoid damaging the drain or inlet
hose.
• Make sure that the line is not kinked or sharply
bent.
