3
System Setting
System Setting
24
S
ys
tem Se
tting
3
Initial Setup
When you turn on the unit for the first time, the
initial setup wizard appears on the screen. Set the
display language and network settings on the initial
setup wizard.
1. Press
1
(POWER).
The initial setup wizard appears on the screen.
2. Use
W/S/A/D
to select a display language
and press ENTER (
b
).
3. Read and prepare the preparations for the
network settings and then press ENTER (
b
)
while [Start] is highlighted.
If wired network is connected, the network
connection setting will automatically be
finished.
If you have security on your access point, you
need to input the security code as necessary.
4. Select [Next] and press ENTER (
b
).
Read and prepare the preparations for the
wireless speaker setting.
5. Select [Next] and press ENTER (
b
).
6. Press ENTER (
b
) to verify the test tone signals of
the speakers.
After verifying the test tone signals, press ENTER
(
b
) while [Stop] is highlighted.
Select [Next] and press ENTER (
b
).
7. You can listen to TV sound through HTS Speaker
automatically when TV is turned on. TV and HTS
should be connected with optical cable. Press
W
to move and press
A/D
to select [On] or
[Off ]. Select [Next] and press ENTER (
b
).
8. Check all the settings that you have set in the
previous steps.
Press ENTER (
b
) while [Finish] is highlighted
to finish the initial setup settings. If there is any
settings to be changed, use
W/S/A/D
to
select
1
and press ENTER (
b
).