Installation
Selection
of the best location
1) Indoor unit
•
There should not be any heat source or steam
near the unit.
•
There should not be any obstacles to prevent
the air circulation.
•
A place where air circulation in the room will
be good.
•
A place where drainage can be easily
obtained.
•
A place where noise prevention is taken into
consideration.
•
Do not install the unit near the door way.
•
Ensure the spaces indicated by arrows from
the wall, ceiling, or other obstacles.
•
The indoor unit must keep the maintenance
space.
2) Outdoor unit
•
If an awning is built over the unit to prevent direct sunlight or rain exposure, be careful that
heat radiation from the condenser is not restricted.
•
There should not be any animals or plants which could be affected by hot air discharged.
•
Ensure the spaces indicated by arrows from the wall, ceiling, fence or other obstacles.
Unit:cm
Ceiling
Ceiling Board
Ceiling Board
At least 180 360 or less
00
1
ero
m r
o
50 or
more
50 or
more
ss
el r
o
03
Floor
More than
30cm
e
c
n
e
F
r
o
s
el
c
at
s
b
o
More than 70cm
More than 50cm
More than
30cm
More than
30cm
f
o
o
r
n
u
S
More than 50cm
(Service space)
More than
30cm
e
c
n
e
F
r
o
s
el
c
at
s
b
o
More than 70cm
More than 50cm
More than
30cm
More than
30cm
f
o
o
r
n
u
S
3) Settlement of outdoor unit
•
Anchor the outdoor unit with a bolt and nut(ø10mm)
tightly and horizontally on a concrete or rigid mount.
•
When installing on the wall, roof or rooftop, anchor the
mounting base securely with a nail or wire assuming the
influence of wind and earthquake.
•
In the case when the vibration of the unit is conveyed to
the hose, secure the unit with an anti-vibration rubber.
Bolt
Tubing connection
10 or more
Installation Manual
7