LG APNW48GTA0, Owner'S Manual, Page: 12 / 19

12
OPERATING INSTRUCTIONS
ENGLISH
Cooling Mode
1
Press button to turn on the indoor.
2
Press
a
button to select Cooling opera-
tion mode.
- When canceling operating, press but-
ton once more.
3
Adjust the desired temperature by press-
ing (
) buttons.
- If desired temperature is higher than
room temperature, cooling cannot be con-
ducted.
- Set the temperature lower than the room
temperature
- Setting Temp Range : 18°C~30°C.
Heating Mode
1
Press button to turn on the indoor.
2
Press
d
button to select Heating opera-
tion mode.
- When canceling operation, press but-
ton once more.
3
Adjust the desired temperature by press-
ing (
) buttons.
- If desired temperature is lower than room
temperature, heating cannot be con-
ducted.
- Set up desired temperature higher than
the room temperature
- Setting Temp Range : 16°C~30°C.
Airflow Setting
We can simply adjust the desired airflow di-
rection.
Up/Down Airflow Direction Control
1
Press button to turn on the indoor.
2
Press button and the louvers will swing
up and down.
3
Press button again to set the horizontal
louver at the desired airflow direction.
Left/Right Airflow Direction Control
1
Press button to turn on the indoor.
2
Press button and the louvers will swing
left and right.
3
Press button again to set the vertical
louver at the desired airflow direction.
<Airflow Setting Table>
Fan Speed Mode
1
Press button to turn on the indoor.
2
Press button to select fan speed.
- You can select the fan speed in four
steps low, mid, high, super high. Each
time the button is pressed, the fan speed
mode is shifted
- Air flow rate can be selected during the
cooling, heating, dehumidification, blow-
ing, and auto operation mode.
NOTE
!
What is 3 minutes delay function?
The reason that cold wind is not coming out
when operating the unit after turning off the
cooling is because of the function to protect
compressor. Cold wind will be coming out
when compressor is operated after 3 minutes.
NOTE
!
Preheating operation
When conducting heating operation at the
condition of low outdoor temperature, the
case that wind is not coming out for several
minutes under the state of lighting of de-
frost lamp may be occurred. This is the pre-
heating stage to supply warm wind which
will be supplied subsequently in short time.
Symbol Description
Up·Down : Vane move from up to
down automatically and continu-
ously
Left·Right : Vane move from left to
right automatically and continuously
OPERATING INSTRUCTIONS