56
206-4340
Remote Jack Pack Setup
RJP Available? If you will use a Remote Jack Pack (RJP) in your system, set Installer Menu item
093
RJP AVAILABLE
appropriately (for example, on a legacy model RJP: HDMI Mode, set RJP AVAILABLE
to 1). See Installer Menu detailed descriptions for further information.
TV Connections
Caution: Make these connections ONLY after Master TV Setup and TV cloning procedures
are complete. Also, make sure to use the RJ45 Control cable from the RJP cable bundle to
make the connection to the TV’s RJP port. Do NOT connect a standard Ethernet cable to
the RJP port, as this may damage the TV and network equipment.
Refer to the figure below, and connect the RJ45 Control cable from the RJP cable bundle to the RJP port
on the TV’s rear jack panel. Then, connect HDMI, and Composite Video/Audio connectors, as applicable,
for the cable bundle.
Reference: Remote Jack Pack / TV Connections & Setup
093 RJP AVAILABLE 001
AV IN / AUDIO IN
L
R
SPEAKER OUT
LINE OUT
RJP Use Only
GAME CONTROL
/ MPI
L/MONO
-AUDIO-
R
ANTENNA /
CABLE IN
LAN
VIDEO
RESET
UPDATE
IN
SERVICE ONLY
TV-LINK CFG
1
OPTICAL
DIGITAL
AUDIO OUT
RS-232C IN (CONTROL&SERVICE)
HDMI IN 1
Connect HDMI connector
from RJP cable bundle.
RJP Use Only
Connect RJ45 Control cable
from RJP cable bundle.
AUDIO/VIDEO IN
Connect Composite Video/Audio
connectors from RJP cable bundle.
(Composite Video on legacy RJP only.)
Note:
RGB is not supported on these TV models. If an RGB source is connected to a legacy
RJP, you will see a brief message on-screen to indicate that this device is not supported.
