LG 28LM4 0B-PU Series, Service Manual, Page: 3 / 69

- 3 -
6$)(7<35(&$87,216
,03257$176$)(7<127,&(
Many electrical and mechanical parts in this chassis have special safety-related characteristics. These parts are identified by in the
Exploded View.
It is essential that these special safety parts should be replaced with the same components as recommended in this manual to prevent
Shock, Fire, or other Hazards.
Do not modify the original design without permission of manufacturer.
*HQHUDO*XLGDQFH
An LVRODWLRQ 7UDQVIRUPHU VKRXOG DOZD\V EH XVHG during the
servicing of a receiver whose chassis is not isolated from the AC
power line. Use a transformer of adequate power rating as this
protects the technician from accidents resulting in personal injury
from electrical shocks.
It will also protect the receiver and it's components from being
damaged by accidental shorts of the circuitry that may be
inadvertently introduced during the service operation.
If any fuse (or Fusible Resistor) in this TV receiver is blown,
replace it with the specified.
When replacing a high wattage resistor (Oxide Metal Film Resistor,
over 1 W), keep the resistor 10 mm away from PCB.
Keep wires away from high voltage or high temperature parts.
%HIRUHUHWXUQLQJWKHUHFHLYHUWRWKHFXVWRPHU
always perform an $& OHDNDJH FXUUHQW FKHFN on the exposed
metallic parts of the cabinet, such as antennas, terminals, etc., to
be sure the set is safe to operate without damage of electrical
shock.
/HDNDJH&XUUHQW&ROG&KHFN$QWHQQD&ROG&KHFN
With the instrument AC plug removed from AC source, connect an
electrical jumper across the two AC plug prongs. Place the AC
switch in the on position, connect one lead of ohm-meter to the AC
plug prongs tied together and touch other ohm-meter lead in turn to
each exposed metallic parts such as antenna terminals, phone
jacks, etc.
If the exposed metallic part has a return path to the chassis, the
measured resistance should be between 1 MΩ and 5.2 MΩ.
When the exposed metal has no return path to the chassis the
reading must be infinite.
Another abnormality exists that must be corrected before the
receiver is returned to the customer.
/HDNDJH&RW&KHFN
(See below Figure)
Plug the AC cord directly into the AC outlet.
'RQRWXVHDOLQH,VRODWLRQ 7UDQVIRUPHU GXULQJWKLVFKHFN
Connect 1.5 K / 10 watt resistor in parallel with a 0.15 uF capacitor
between a known good earth ground (Water Pipe, Conduit, etc.)
and the exposed metallic parts.
Measure the AC voltage across the resistor using AC voltmeter
with 1000 ohms/volt or more sensitivity.
Reverse plug the AC cord into the AC outlet and repeat AC voltage
measurements for each exposed metallic part. Any voltage
measured must not exceed 0.75 volt RMS which is corresponds to
0.5 mA.
In case any measurement is out of the limits specified, there is
possibility of shock hazard and the set must be checked and
repaired before it is returned to the customer.
/HDNDJH&RW&KHFNFLUFXLW
2019