LG SIGNATURE WM9500H*A, Owner'S Manual

Page: 22 / 108

22
OPERATION
Control Panel
1
2
3
4
5
4
Control Panel Features
1
Power On/Off Button
Press to turn the washer on. Press again to turn the
washer off. Pressing the Power button during a cycle
will cancel that cycle and any load settings will be
lost. The door will unlock after a brief pause.
2
Start/Pause Button
Press this button to start the selected cycle. If the
washer is running, use this button to pause the cycle
without losing the current settings.
NOTE
• If Start/Pause is not pressed within 60 minutes of
selecting a cycle, the washer automatically turns off
and all cycle settings are lost.
3
Cycle Modifier Buttons
Use these buttons to adjust the water temperature,
spin speed and soil level settings for the selected
cycle. The current settings are shown in the display.
Press the button for that option to select other
settings.
4
Special Cycle and Option Buttons
These buttons allow you to select special cycles or
additional cycle options. Certain buttons also allow
you to activate special functions by pressing and
holding the button for three seconds.
5
Time and Status Display
The display shows the settings, estimated time
remaining, options, and status messages for your
washer. When the washer is turned on, the default
settings in the display will illuminate.
Door Lock Indicator
The Door Lock indicator will light up once a cycle has
started. The indicator light will stay on until the cycle
is paused, stopped or has finished.
Child Lock Indicator
When the Child Lock function is activated, a
message and the remaining wash time are displayed,
in turn, on the display panel of the washer. When the
Child Lock function is set, all controls are disabled
except for the Power button.
Cycle Status Indicator
These LEDs will illuminate when a cycle is selected
to indicate which stages will run. When a cycle is
running, the LED for the active stage will blink, and
the LEDs for the remaining stages will remain steady.
Once a stage is complete, the LED will turn off. If
a cycle is paused, the active stage LED will stop
blinking.
Estimated Time Remaining
When a cycle is selected, the default time for that
cycle is displayed,. This time will change as modifiers
or options are selected. Once the Start/Pause button
is pressed, the washer will measure the size of the
load. The estimated time may change once the load
size has been measured. If Delay Wash is set, the
remaining delay time counts down until the cycle
begins.
NOTE
• The time shown is only an estimate. This time is
based on normal operating conditions. Several
external factors (load size, room temperature,
incoming water temperature,etc.) can affect the
actual time.