LG SIGNATURE WD1610NSW, Owner'S Manual

Page: 57 / 64

57
EN
Error Messages
Symptoms Reason Solution
Water supply may be too low or too
high in the area.
•
Check another tap in the house.
Water supply taps are not
completely open.
• Fully open tap.
Water supply hose(s) are kinked. • Straighten hose(s).
The filter of the supply hose(s) are
clogged.
•
Check the filter of the supply hose.
If water leakage occurred in the
aqua stop supply hose, indicator
will become red.
This type of inlet hose may not
apply to all models.
• Use the aqua stop supply hose. (not
applicable to all models)
Load is too small.
• Add 1 or 2 similar items to help
balance the load.
Too much detergent.
•
Reduce the dispensing amount if
suds are visible in the tub.
Load is out of balance.
•
Add 1 or 2 similar items to help
balance the load.
The appliance has an imbalance
detection and correction system. If
individual heavy articles are loaded
(e.g. bath mat, bath robe, etc.) this
system may stop spinning or even
interrupt the spin cycle altogether.
• Rearrange load to allow proper
spinning.
If the laundry is still too wet at the
end of the cycle, add smaller articles
of laundry to balance the load and
repeat the spin cycle.
• Rearrange load to allow proper
spinning.
Drain hose is kinked or clogged.
•
Clean and straighten the drain hose.
The drain filter is clogged.
• Clean the drain filter.