30
OPERATION
Control Panel
1
3
2
6
4
5
1
Power
•
Press the
Power
button to turn power on and off.
•
After the cycle is complete, the power automatically
turns off for purposes of safety and economy.
•
If there is a power surge, power outage, or
disruption of any kind, power is automatically turned
off for safety.
•
When power is connected again, it will turn on
automatically and resume the cycle.
2
Rinse Refill
This lamp illuminates when the rinse aid level is low.
The LED automatically shuts off when the rinse aid is
refilled or the level is set to 0.
3
Digital Display
The digital display on the control panel shows the
ESTIMATED cycle time. When the cycle and options
are selected, the display shows the total estimated
time to complete those selections. During operation,
the display shows the remaining estimated operating
time.
NOTE
•
The estimated time shown on the display does not
include delay times for heating water, etc.
•
If
Delay Start
is selected, the display shows the
delay time in hours.
•
Cycle time may vary depending on the soil level of
your load.
4
Control Lock
The Control Lock feature helps prevent settings from
being changed during a cycle. Selecting this feature
locks all of the buttons, except for the
Power
button,
on the control panel. This feature does not lock the
door.
•
While a cycle is running, press and hold
Dual Zone
for three seconds to activate or deactivate Control
Lock.
•
To start a new cycle, deactivate Control Lock.
5
Cancel
The drain pump activates and the cycle cancels.
Once the dishwasher finishes draining, the power
turns off.
•
Press and hold
Start
for three seconds to activate.
6
Start
•
To operate the machine, either press
Start
and
close the door within four seconds or close the door
and press
Start
.
•
If
Start
button is not pressed to start the cycle, an
alert will sound.
Chime On/Off
•
To activate or deactivate the button sounds, press
the
Half Load
button for three seconds. The error
alert sound cannot be turned off.
Wi-Fi
When the appliance is connected to the internet
through a home Wi-Fi network, this icon illuminates.
•
Press and hold
Delay Start
for approximately three
seconds to connect to the network.
Summary of Contents for LUDP899 Series
