17
EN
Leveling the Appliance
If the floor is uneven, turn the adjustable feet
as required (Do not insert pieces of wood etc.
under the feet). Make sure that all four feet are
stable and resting on the floor and then check
that the appliance is perfectly level (Use a spirit
level).
•
Once the appliance is level, tighten the lock
nuts up towards the base of the appliance. All
lock nuts must be tightened.
Raise
Lower
Lock nut
Tighten all 4
lock nuts securely
Diagonal Check
•
When pushing down the edges of the top plate
diagonally, the appliance should not move up
and down at all (check both directions). If the
appliance rocks when pushing the machine
top plate diagonally, adjust the feet again.
NOTE
•
Timber or suspended type flooring may
contribute to excessive vibration and
unbalance.
•
If the washing machine is installed on a raised
platform, it must be securely fastened in order
to eliminate the risk of falling off.
Connecting Supply Hose
•
Water supply pressure must be between 0.1
MPa and 1.0 MPa (1.0‒10.0 kgf/cm
2
).
•
Do not strip or crossthread when connecting
inlet hose to the valve.
•
If the water supply pressure is more than
1.0 MPa, a decompression device should be
installed.
•
Periodically check the condition of the hose
and replace the hose if necessary.
Checking the Rubber Seal on the
Supply Hose
Two rubber seals are supplied with the water
inlet hoses. They are used for preventing water
leaks. Make sure the connection to taps is
sufficiently tight.
Hose connector
Rubber seal
Hose connector
Rubber seal
