LEYBOLD ECODRY plus 25, Operating Instructions Manual, Page: 19 / 64

2. Remove the packing material. Keep all the packing materials for use in
the inspection and if the pump is returned for service.
3. Examine the pump for damage. If the pump is damaged, notify your
supplier and the carrier immediately. Give the supplier and the carrier
the information that follows:
▪ part number of the pump
▪ serial number of the pump
▪ order number
▪ supplier's invoice number
4. Do not use the pump if the pump is damaged.
5. If the pump is not to be used immediately, store the pump in the
conditions given in
Storage on page 54.
6. Do not remove the seals until the pump is ready to be installed on the
vacuum system. The pump is supplied with sealed inlets and an outlet
to prevent the entry of dust and vapour.
4.2 Mechanical installation
WARNING: HEAVY OBJECT
Risk of physical injury. Use suitable equipment to lift the pump.
WARNING: TRIP HAZARD
Risk of injury or damage to equipment. Make sure that any cables and/or pipe work
attached to the pump are fixed carefully to avoid a slip/trip hazard and to prevent any
damage to the cable.
WARNING: LIFTING EYE INTEGRITY
Risk of injury or damage to equipment. Make sure that the maximum angle between
the paired slings used to lift the system is 45 degrees. Increased angle could
compromise the lifting eye integrity.
WARNING: INSTALLATION SAFETY
Risk of injury or damage to equipment. Install the pump in the vacuum system before
you connect the power supply. This will make sure that the pump is not operated and
this will avoid injury during the installation.
WARNING: STATIC PRESSURE
Risk of damage to equipment. Do not step or stand on the pump, it is not designed
to withstand large static loads.
19
300902516_002 - 10/2020 - © Leybold
Installation