Lexus RX350 2023, Manual

Page: 52 / 604

52
1-2. Child safety
A child restraint system for a small
child or baby must itself be properly
restrained on the seat with the lap por-
tion of the lap/shoulder belt.
■
Installing child restraint system
using a seat belt (child restraint
lock function belt)
Install the child restraint system in
accordance to the operation manual
enclosed with the child restraint sys-
tem.
For Puerto Rico: If the child restraint
system on hand is not within the “uni-
versal” category (or the necessary
information is not in the table), refer to
the “Vehicle List” provided by the child
restraint system maker for various pos-
sible installation positions, or check the
compatibility after asking the retailer of
the child seat. (

P.45)
■
Rear-facing

Infant seat/con-
vertible seat
1 Adjust the rear seat.
If there is a gap between the child seat and
the seatback, adjust the seatback angle
until good contact is achieved.
2 Place the child restraint system on
the rear seat facing the rear of the
vehicle.
3 Run the seat belt through the child
restraint system and insert the plate
into the buckle. Make sure that the
belt is not twisted.
4 Fully extend the shoulder belt and
allow it to retract to put it in lock
mode. In lock mode, the belt cannot
be extended.
5 While pushing the child restraint
system down into the rear seat,
allow the shoulder belt to retract
Child restraint system fixed with
a seat belt