Lexmark Z51 Color Jetprinter, Service Manual

Page: 31 / 70

Diagnostic Aids
3-3
4098-001
End of Forms (EOF) Test
To Start the Test:
•
Unplug power to the printer.
•
Remove the rear cover.
•
Place a 2 pin jumper on J13.
•
Hold down the Power and Paper Feed buttons.
•
Plug power to the printer.
•
Release the buttons when the Power Light flashes
(approximately 5 seconds).
To Test:
•
Place a piece of paper in the manual feeder to activate the end-
of-forms sensor.
•
The Busy Light will come on when the flag is removed from the
sensor and will be off when the flag is in the sensor.
•
Unplug the printer power or press the Power button to end
the test.
•
Remove the jumper from J13.