Note:
If you do not have a replacement imaging unit, then see the “Ordering supplies” section of the
User’s Guide
or visit
Replace jammed originals if restarting job.
Try one or more of the following:
•
Touch
Cancel job
to clear the message and cancel the scan job.
•
Touch
Scan from automatic feeder
to continue scanning from the ADF immediately after the last
successful scan job.
•
Touch
Scan from flatbed
to continue scanning from the scanner immediately after the last successful
scan job.
•
Touch
Finish job without further scanning
to end the last successful scan job.
•
Touch
Restart job
to restart the scan job with the same settings from the previous scan job.
Replace last scanned page and jammed originals if restarting job.
Try one or more of the following:
•
Touch
Cancel job
to clear the message and cancel the scan job.
•
Touch
Scan from automatic feeder
to continue scanning from the ADF immediately after the last
successful scan job.
•
Touch
Scan from flatbed
to continue scanning from the scanner immediately after the last successful
scan job.
•
Touch
Finish job without further scanning
to end the last successful scan job.
•
Touch
Restart job
to restart the scan job with the same settings from the previous scan job.
Replace maintenance kit, recommended life exceeded [80.xy]
The printer is scheduled for maintenance. For more information, go to
contact your service representative.
Replace maintenance kit to resume printing [80.xy]
The printer is scheduled for maintenance. For more information, go to
contact your service representative.
Replace missing cartridge [31.xy]
Install the missing cartridge to clear the message. For more information, see
“Replacing the toner cartridge”
.
Replace missing fuser [80.xx]
1
Install the missing fuser. For more information, see the instruction sheet that came with the replacement
part.
2
From the control panel, touch
Supply replaced
to clear the message.
Troubleshooting
304
