Lexmark XC2132, Service Manual, Page: 223 / 430

9
Repeat steps 5 and 6 as needed.
10
To exit REGISTRATION, select Back or Stop .
Disable scanner
This menu item is used to disable the MFP scanner if it is malfunctioning. The MFP must be powered off and on for the
new settings to take effect.
To change this setting:
1
Select Disable Scanner from the Configuration menu.
2
Scroll through the setting's other possible values. The values are Enable, Disable, ADF disable.
3
To save the setting's new value, select Submit .
Auto Color Adjustment
Auto Color Adjustment sets the suggested number of pages which the printer should print between consecutive
calibrations.
Selections are Off and the values between 100 and 1000 in increments of 50. The default is 500 pages.
If the printer exceeds the set value while printing a job, it completes the current job and any other jobs received while
printing the current job before it initiates a calibration. The printer does not cancel or suspend an active job to perform
a calibration. If a user is using the menus, including the Configuration Menu and the Diagnostics Menu, an automatic
color adjust calibration does not occur.
When an event other than page count triggers this calibration, the count that monitors the maximum number of pages
printed will be reset. For example, if the user replaces an empty toner cartridge, the next time the printer is started, it
will sense the new cartridge and perform the automatic color adjustment, even though the page counter for Auto Color
Adj is fewer than required. The Auto Color Adj page counter is then reset.
Font Sharpening
Font Sharpening allows a user to set a text point-size value below the setting of the high-frequency screens used when
printing font data. This menu item affects only the PostScript, PCL 5, PCL XL, and PDF emulators.
Settings are in the range of 0–150 (24 is the default). For example, if the value is set to 24, then all fonts sized 24 points
or less use the high-frequency screens. To increase the value by 1, press the right arrow; to decrease the value by 1,
press the left arrow.
Exit Config
Press Select to exit the Configuration Menu. The printer performs a power-on reset and returns to normal mode.
7527
Service menus
223