Lexmark XC2132, Service Manual, Page: 220 / 430

This setting enables a user to restore all of the device settings to either the network settings (on network models only)
or to the base device settings.
To print current menu settings:
Note: It is recommended that you first print the customer’s current settings by printing a copy of the Menu Settings
pages. Customer settings are available from the Ready prompt Diagnostics Menu settings are available in the
Diagnostics Menu, and Config Menu settings are available in the Config Menu.
1
Turn the printer off, or select Exit Config Menu .
2
At the Ready prompt, select Menus and press Select .
3
Select Reports , and press Select .
4
Select Menu Settings Page , and press Select .
5
Enter the Diagnostic Menu, select Reports , Menu Settings Page , and press Select .
6
Turn the printer off, or select Exit Diags .
7
Enter Configuration Menu, select Reports , Menu Settings Page , and press Select .
To reset factory defaults:
1
Select Reports from the Config Menu, and press Select .
2
Select Factory Defaults , and press Select
3
Select Restore Base (for locally attached printers) or Restore STD NET (if you have integrated network support).
Submitting Changes…
appears on the operator panel, and then the printer PORs (restarts in Ready mode).
Energy Conserve
Energy Conserve affects the values that appear in the Power Saver menu in the customer Setup Menu. This menu item
appears only when the printer model does not support Automatic Power Saver or has deactivated Automatic Power
Saver. Energy Conserve affects only the values that are displayed in the Power Saver menu.
Select Off in Energy Conserve to allow Power Saver in the customer menu to display Disable as an option. If Disable is
selected in the customer Power Saver, the printer deactivates the Power Saver feature. Select On (the default) in Energy
Conserve to prevent Disable from appearing as an option in the Power Saver setting, and preventing the customer
from turning off Power Saver.
Fax low power support
Fax Low Power support allows you to select one of three power settings for the fax. The Auto value relies on the
firmware’s logic to determine if the device supports the fax portion of the low power architecture. Permit Sleep allows
the fax chip to enter low power mode whenever the device determines that it should. Disable Sleep prohibits the fax
chip from ever entering low power mode.
To change the fax low power support setting:
1
Select Fax low-power support in the configuration menu to open the item
2
Select one of the three settings: disable, sleep permit, or sleep auto.
3
Select to accept the setting, or press the X on the screen to exit the item.
7527
Service menus
220